![]() ![]() Vector Engrave : 60mm/s :Power 4ma : Single Pass Raster Engrave : 300mm/s : Power 80ma : Single Pass Vector Cut : 10mm/s : Power 10ma : Single Pass ![]() Vector Engrave : 60mm/s : Power 5ma : Single Pass Raster Engrave :250mm/s : Power 8ma : Single Pass Vector Cut: 8mm/s : Power 10ma : Single Pass K40 Laser Cutter Glass Settings Vector Engrave: 60mm/s : Power 5ma : Single-pass Raster Engrave : 400mm/s : Power 10ma : Single Pass The k40 will cut through the wood at approx 1mm per pass with the stock setup (without air-assist and upgraded lenses mirrors etc) K40 Laser Cutter Acrylic Settings Softwoods will cut a little deeper, so keep this in mind when inputting your settings into your K40 laser cutter K40 laser cutter wood settings 5 mm deep, which carries through most hard and softwoods. They have been very accurate nearly every-time for the result I usually look for in timber and other materials. The K40 laser settings listed below is a beginner’s guide to get you started on your projects. ![]()
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |